Velleman CAMIP5N Manual Del Usuario página 7

• When connected to a DHCP router, check the 'Obtain IP from DHCP server' checkbox, otherwise
uncheck it and fill in the data manually.
• In case of a subnet mismatch, change the IP-address or subnet mask.
• When in doubt about the network settings, contact a qualified network administrator.
Upgrade firmware
• Only use this option when problems with the current version are noticed. Do not upgrade if the
camera works fine.
• Caution: when the upgrade process is interrupted or a wrong version is installed the camera
might not work anymore.
• The administrators' login and password are required.
Note: default administrator login is admin without a password.
Refresh Camera List
• Use this option to update the camera list, e.g. when a new camera is added to the network.
Flush ARP Buffer
• When both a wireless and wired connection to a camera exists, a problem with the ARP (Address
Resolution Protocol) may arise resulting in the camera not being accessible via the browser. In
this case the ARP buffer should be cleared
About IP Camera Tool
• Show some extra information about the camera tool.
8.2 Camera login
• When the network set-up is completed, double click on the camera to open the camera window. A
web browser with a login page is opened:
Note: it is also possible to open a browser window and enter the cameras' IP address in the
address bar.
13.12.2010
CAMIP5N
7
©Velleman nv