Electrical Requirements; Unpack The Refrigerator - Impecca RA-2107 Manual De Usuario

To ensure proper ventilation for your refrigerator, allow for 2"
(5.08 cm) of space on each side and at the top. Allow for 4" (10
cm) of space behind the refrigerator. When installing your re-
frigerator next to a fixed wall, leave 4" (10 cm) minimum to
allow for the door to swing open.
NOTE: This refrigerator is intended for use in a location where
the temperature ranges from a minimum of 55°F (13°C) to a
maximum of 110°F (43°C). The preferred room temperature
range for optimum performance, which reduces electricity
usage and provides superior cooling, is between 60°F (16°C)
and 90°F (32°C). It is recommended that you do not install the
refrigerator near a heat source, such as an oven or radiator, or
in direct sunlight.

ELECTRICAL REQUIREMENTS

I WARNING
ELECTRICAL SHOCK HAZARD
PLUG INTO A GROUNDED 3 PRONG OUTLET.
DO NOT REMOVE THE GROUND PRONG FROM THE POWER
CORD PLUG.
DO NOT USE AN ADAPTER.
DO NOT USE AN EXTENSION CORD.
FAILURE TO DO SO CAN RESULT IN DEATH, FIRE OR ELECTRI-
CAL SHOCK.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical connec-
tion.
RECOMMENDED GROUNDING METHOD
A 115 volt, 60 Hz, AC only 15- or 20-amp fused, grounded elec-
trical supply is required. It is recommended that a separate
circuit serving only your refrigerator be provided. Use an outlet
that cannot be turned off by a switch. Do not use an extension
cord.
NOTE: Before performing any type of installation or cleaning,
disconnect the refrigerator from the electrical source. When
you are finished, reconnect the refrigerator to the electrical
source and reset the temperature controls to the desired set-
ting.

UNPACK THE REFRIGERATOR

I WARNING
FIRE OR EXPLOSION HAZARD
DO NOT PUNCTURE REFRIGERANT TUBING.
FOLLOW HANDLING INSTRUCTIONS CAREFULLY.
FLAMMABLE REFRIGERANT USED.
FAILURE TO DO SO CAN RESULT IN DEATH, EXPLOSION OR
FIRE.
I WARNING
EXCESSIVE WEIGHT HAZARD
USE TWO OR MORE PEOPLE TO MOVE AND INSTALL REFRIG-
ERATOR.
FAILURE TO DO SO CAN RESULT IN BACK OR OTHER INJURY.
REMOVE THE PACKAGING
• Remove tape and glue residue from surfaces before turning
on the refrigerator. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Rinse with warm water
and dry.
• Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator. For
more information, see "Refrigerator Safety."
• Remove foam block(s) inserted between the compressor
motor and the cabinet, as shown.
• Dispose of/recycle all packaging materials.
NOTE: Do not remove the plastic drain tray located above the
compressor motor on models with auto-defrost.
A. Foam Blocks
B. Compressor
–5–