Publicidad
Idiomas disponibles
Idiomas disponibles
2. Installation location
Outdoor unit
en
3
Branch box
5-branches type
3-branches type
Fig. 2-1
(inch)
Fig. 2-2
2.1. Before installation (Fig. 2-1)
This installation manual is only for the outdoor unit installation. In installing
the indoor units and branch box, refer to the installation manual attached
to each unit.
Any structural alterations necessary for the installation must comply with the local
building code requirements.
This diagram is intended to show the configuration of accessories.
For actual installation, the outdoor unit is to be turned 180°.
Units should be installed by licensed contractor according to local code requirement.
Note:
The dimensions given along the arrows above are required to guarantee the
air conditioner's performance. Install the unit in as wide a place as possible
for later service or repairs.
Parts to be locally procured
Branch box/outdoor unit connecting wire (3-core)
Extension pipe
Wall hole sleeve
Wall hole cover
Pipe fixing band
(The quantity depends on the pipe length.)
Fixing screw for
4 × 20 mm (13/16")
(The quantity depends on the pipe length.)
Piping tape
Putty
Refrigeration oil
Power supply cord (2-core, Refer to 6.3. Wiring transmission cables)
2.2. Refrigerant pipe
Refer to Fig. 4-1.
2.3. Choosing the outdoor unit installation location
• Avoid locations exposed to direct sunlight or other sources of heat.
• S elect a location from which noise emitted by the unit will not inconvenience
neighbors.
• S elect a location permitting easy wiring and pipe access to the power source and
indoor unit.
• Avoid locations where combustible gases may leak, be produced, flow, or accumu-
late.
• Note that water may drain from the unit during operation.
• Select a level location that can bear the weight and vibration of the unit.
• A void locations where the unit can be covered by snow. In areas where heavy
snow fall is anticipated, special precautions such as raising the installation location
or installing a hood on the air intake must be taken to prevent the snow from
blocking the air intake or blowing directly against it. This can reduce the airflow and
a malfunction may result.
• Avoid locations exposed to oil, steam, or sulfuric gas.
• U se the transportation handles of the outdoor unit to transport the unit. If the unit is
carried from the bottom, hands or fingers may be pinched.
2.4. Outline dimensions (Outdoor unit) (Fig. 2-2)
1
1
1
1
2 to 7
2 to 7
1
1
1
1
Publicidad
