Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
(Continued)
• Save all instructions
H
Clutch Lever
CAUTION
THIS INFORMATION IS PROVIDED HERE ONLY TO INTRO-
DUCE THE CONTROLS. DO NOT START THE ENGINE AT THIS
TIME. STARTING AND OPERATING INSTRUCTIONS ARE GIVEN
ON PAGE 11. PLEASE READ THIS SECTION AND ALL OPERAT-
ING AND SAFETY INSTRUCTIONS BEFORE STARTING YOUR
TILLER.
WARNING
DO NOT FIx THE CLUTCH LEVER IN DRIVE POSITION bY ANY
OTHER MEANS THAN MANUALLY USING YOUR HAND. DO
NOT TIE OR OTHERWISE SECURE THE LEVERS IN DRIVE
POSITION.
•
TO STOP THE TINES AT ANY TIME RELEASE THE CLUTCH
LEVERS.
CLUTCH LEVER
(See Figure 13)
Engages tines into forward. Pushing down the clutch lever
toward the handle bar engages the tines. Releasing the lever
stops the tines and brings the tiller to a complete stop.
Forward Lever Engaged
Questions? Call Toll Free at 1-800-737-2112
I
Adjustments
WARNING
ENGINE SHOULD bE OFF bEFORE
ADJUSTING ANY CONTROLS.
DRAG BAR
Tilling depth is controlled by the height of the
drag bar. To adjust tilling depth:
1. Remove detent pin.
2. Adjust the drag bar to position tines at chosen tilling depth.
3. Align hole in drag bar with hole in drag bar and replace
detent pin.
Drag Bar Up = Shallower tilling.
Place the detent pin in the bottom hole of the depth regulator
lever for shallowest tilling.
Drag Bar Down = Deeper tilling.
Place the detent pin in the top hole of the depth regulator lever
for deepest tilling.
WARNING
DO NOT ADJUST TILLING DEPTH UNLESS CLUTCH LEVER IS
RELEASED AND ENGINE IS TURNED OFF.
Figura 13
13
(See Figure 2)
Copyright © 2011 MAT Engine Technologies, LLC
Publicidad
