Publicidad
Idiomas disponibles
Idiomas disponibles
en-us Faults – what to do?
Ice maker
The ice maker is not functioning.
Ice cube production is switched off.
Freezer compartment is too warm.
Ice cube container is not properly inserted.
Ice maker without power.
No water supply.
Low water pressure.
Kink in water hose.
Too few or deformed ice cubes, water pressure lower than usual.
After switching on or removing many ice cubes, there will be too few
in the ice cube container.
Ice cube production stops even though the ice cube container is still
not full.
Low water pressure.
The water filter is blocked or needs to be replaced.
Freezer compartment is too warm.
Water is leaking out of the appliance.
Water connection is not tight.
--------
20
Switch on ice cube production.
Set the temperature lower.
~ "Operating the appliance" on page 12
Insert ice cube container fully.
Call customer service.
~ "Customer service" on page 21
Check water connection and contact technician if necessary.
Only connect appliance to pipes with sufficient water pressure.
Turn off water supply, straighten out kink. Replace water hose, if nec-
essary.
It takes around 24 hours for an empty ice cube container to fill up.
Do not store the ice shovel on the ice in the ice cube container. Other-
wise, the sensor will not detect the actual fill level of the container.
Only connect appliance to pipes with sufficient water pressure.
Replace water filter.
Set the temperature lower.
~ "Operating the appliance" on page 12
Check if the connections are fastened firmly and the water hose is
undamaged.
If the water hose is damaged, contact customer service and have it
replaced. Replacement must be performed by customer service or a
similarly qualified person only.Use original parts supplied by the man-
ufacturer only.
Publicidad
