Publicidad
Idiomas disponibles
Idiomas disponibles
G. handle
h. frame
I.
Pump Outlet
J.
Pump Inlet
k. Quick Connect Nozzles
L.
Nozzle holder (not shown)
BASIC ELEMENTS OF AN ENGINE
Refer to the engine manual for location and operation of engine controls.
Choke Control: Opens and closes carburetor choke valve.
Starter Grip: Pulling starter grip operates recoil starter to crank engine.
Engine Switch: Enables and disables ignition system.
1.
Locate and remove all loose parts from the carton.
2.
Cut four corners of the carton from top to bottom and lay the panels flat.
3.
Connect wand (E) to gun (D). Tighten securely.
4.
Attach high pressure hose (C) to gun (D). Tighten se cure ly.
Extension hose (optional): Attach high pressure hose (C) to extension hose
5.
(R). Ensure connections are secure.
2
D
NOTICE: The engine is shipped without oil. Before starting engine, add the oil
provided. Damage to the engine will occur if the engine is run without oil, this
damage will not be covered under warranty.
pRESSURE WASHER TERMINOLOGY
PSI: Pounds per Square Inch. The unit of measure for water pressure. Also used
for air pressure, hydraulic pressure, etc. Sometimes noted as "Bar", another unit
of measure.
GPM: Gallons per Minute. The unit of measure for the flow rate of water.
CU: Cleaning Units. GPM multiplied by psi equals CU.
Bypass Mode: Allows water to re-circulate within the pump when the gun trigger is
not pulled. This feature allows the operator to release the trigger gun and reposition
themselves without having to turn the engine off in between cleaning actions.
NOTICE: Allowing the unit to run for more than two minutes without the gun
trigger being pulled could cause overheating and damage to the pump. Do not let
the pressure washer run for more than two minutes in Bypass Mode. Turn off the
engine and relieve the pressure in the gun during these extended situations.
ASSEMBLY INSTRUCTIONS (FIG. 1– 4)
3
E
OpERATION
D
C
11 - ENG
4
R
C
Publicidad
