Publicidad
Idiomas disponibles
Idiomas disponibles
TENSOR SERIES ACTIVE SUBWOOFER
REAR PANEL CONTROL: TRS-1500 and TRS-1800
1. INPUTS:
ccept balanced and non-balnaced Line level inputs signals compatible with XLRs. The balanced input provides
A
superior noise rejection when using balanced signals over long cable runs.
2. LINK OUT: Output XLR's are hard wired to their corresponding INPUT XLR. These connections can be used to daisy chain
additional TENSOR cabinets.
3. CROSSOVER: This controls the frequency range supplied to the onboard loudspeaker. It doesn't have any effect on the signal
from the High Pass Output connectors.
4. CLIP: The LED will illuminate when a signal is approaching the clipping point. Reduce the Level/Gain control on connected
devices to prevent this. It is worth noting that a clipped signal, apart from sounding bad will not cause damage to the Power
amplifier because of the on-board limiter.
5. POWER: The LED illuminates when the unit it connected to a suitable mains source and the Power Switch is set to on.
6. VOLUME: Use to set the overall output level of the unit. This control does not have an effect on the audio level from the Left
and Right HIGH PASS OUTPUTS.
7. HIGH PASS OUTPUTS: With a cut-off frequency of 95Hz the two balanced connections allow for additional full range
cabinets (such as the TRE-1201 or TRE-1501) to be added to the system. They are not suitable for connecting additional sub-
woofers. It is worth noting that the signals from the INPUTS to the HIGH PASS OUTPUTS are true Stereo and combined
with other cabinets allow for a stereo system. For more information, have a look at the sample setups on page 5.
8. GROUND LINK: This will effectively disconnect the signal ground from the chassis ground and is useful for removing
potential earth loops. Earth loop problems can be detected by the presence of hum from the loudspeakers.
9. SHAPE: The shape function changes the tonal character of the subwoofer. When Depressed, it provides a flat bass response,
but delivers a boost around 95Hz and punchy low end characteristic when engaged.
10. PHASE: Use to provide a 180º phase shift at the loudspeaker output and can be used to correct phase problems when
multiple cabinets are used. Phase problems are evident in the form of reduced or lack of bass. The phase control does not effect
the HIGH PASS OUTPUTS.
11. LOGO: The illumination On/Off control for the logo located on the front speaker Grille.
© 2021 HH Electronics Ltd
2
2
LINK OUTPUTS
RIGHT
INPUTS
1
1
Designed and Engineered in the UK by HH Electronics LTD.
3
CROSSOVER
FREQUENCY
Hz
60
200
CLIP
4
POWER
5
GND
0
10
VOLUME
MASTER
6
8
7
HIGH PASS OUTPUTS
RIGHT
SHAPE
PHASE
LOGO
18O
OFF
O
ON
9
10
11
3
Publicidad
