HH Electronics TENSOR Serie Manual Del Usuario página 4

TENSOR SERIES ACTIVE SUBWOOFER
REAR PANEL CONTINUED
12. AIR VENTS: These are critical for the longevity and reliability
of the amplifier - DO NOT BLOCK.
13. MAINS INLET SOCKET AND FUSE: IEC input for
connection of an appropriate mains lead. Only replace the fuse
with the type indicated on the rear panel.
14. INFORMATION: Safety details.
15. VOLTAGE SELECT SWITCH: Please check the voltage
setting to your region before powering up for the first time.
Damage could occur if the voltage is incorrectly set.
See below for more information.
16. MAINS SWITCH: Turns the system on and off. Ensure the
Volume controls is set to
16. POLE MOUNT: Both the TRS-1500 and TRS-1800 are
equipped with 35mm pole socket.
18. ILLUMINATED HH LOGO.
FUSE REPLACEMENT AND VOLTAGE SELECTION
SWITCH OFF AND DISCONNECT THE POWER CORD BEFORE PROCEEDING.
POWER
© 2021 HH Electronics Ltd
minimum before powering up the unit.
17
18
FUSE REPLACEMENT
1. Slide out the fuse holder tray.
2. Only replace fuse with the same
type and power rating as specified
on the rear panel.
Designed and Engineered in the UK by HH Electronics LTD.
LINK OUTPUTS CROSSOVER
FREQUENCY
Hz
60 200
CLIP
POWER
RIGHT
0 10
VOLUME
INPUTS
12
14
MODEL: TRS-1500
100-120V~
14
~220-240V 50/60Hz T3.15A L 250V
13
VOLTAGE SELECTION
100-120V SETTING
220-240V SETTING
Using a suitable tool, slide the voltage
selector switch to the required
operating voltage.
HIGH PASS OUTPUTS
RIGHT
GND SHAPE PHASE LOGO
18O OFF
O ON
MASTER
12
15
16
4