Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION
Assembly (ref. Figs. 1 & 2)
1. Make sure all parts are present. If any part is missing
or damaged, do not attempt to assemble or operate
the product. Contact Omega Customer service (888)
332-6419.
2. Install ratchet bar into collar, ratchet portion of bar
aligned with locking pawl.
3. Move the ratchet bar to its lowest position by raising
the locking handle, releasing the locking pawl, and
guiding the bar downward.
4. To prevent inadvertent loss of the ratchet bar:
a) For 32035B & 32065B: (Tools required: Hammer,
Punch) Press the collar tab inward using a suitable
hammer and punch.
b) For 32125B: (Tool required: 12mm Wrench) Tighten
the M7.5 x 20 hex bolt found on the collar.
Before Use
1. Read this manual completely and familiarize yourself thoroughly with the product and the hazards associated with
its improper use before using the product.
2. Verify that the product and the application are compatible, if in doubt call
3. Inspect jack stands before each use. Do not use if there are bent, broken or cracked components noted (including
labels). Ensure that all parts move freely.
4. Consult the vehicle owners or service manual for location of proper lift and support points.
OPERATION
WARNING: Support areas of vehicle specified by vehicle manufacturer. Use ONLY on vehicles whose support
!
points are compatible with saddle of jack stand. Incompatibility may result in structural damage to vehicle and/
or jack stand.
1. Adjust height by pulling up on ratchet bar.
2. The weight of locking handle should secure the ratchet bar in desired position. To confirm, push down on the
locking handle. Ensure ratchet and locking pawl are secure before loading.
3. Carefully position jack stands so that load is centered on stand's saddle.
4. Lower the vehicle onto the stands.
5. Ensure vehicle is secure before working on, around or under. Chock all unlifted wheels in both directions to
prevent inadvertent movement.
Removing Jack Stands
!
WARNING: Clear all tools and personnel before lowering load.
1. With suitable jack, raise vehicle clear of stands.
2. Raise locking handle and allow ratchet bar to descend to lowest position.
3. Remove jack stands, then lower vehicle with lifting device.
MAINTENANCE
Periodically inspect each stand. Ensure all parts move freely. Do not apply oil or grease to any portion of this product.
If rust appears, sand affected area and cover with suitable utility paint.
Storage
Store stands in upright position and in a clean, dry area.
WARNING
!
• Study, understand, and follow all instructions
before operating this device.
• Do not exceed rated capacity.
• Use only on hard, level surface.
• Center load on saddle.
• Use as a matched pair only.
• Stands are not to be used to simultaneously
support both ends of a vehicle.
• No alteration shall be made to this device.
• Failure to heed these markings may result in
personal injury and/or property damage.
Omega Customer Service (888) 332-6419.
3
Publicidad
