Escalade Sports T8661G Manual Del Propietário página 7

Figure 12
T op View
Name Panel #5
Safety Latch #8
(Flange extends over
Name Panel #5)
CAUTION:
20. Choose a name panel #5 on either side of the table and install
one safety latch #8 into the right-hand hole on that name panel
as shown in Figures 12 & 13. Use one screw #10 one washer
#17 and one hex nut #16. NOTE: Flange on safety latch
must extend over top of name panel as shown in Figure 12.
Safety latch must pivot freely.
21. Go to the other side of the table and install the second safety latch
into the right-hand hole on the other name panel #5. NOTE:
Safety latches must be attached diagonally across from
each other. (See Figure 13).
22. Attach corner caps #24 to four outside corners of table top. Use
three screws #20 through each cap. (See Figure 14).
24
16
5
17
SAFETY
LATCH
#8
DO NOT OVERTIGHTEN
10
SAFETY LATCHES #8.
THEY MUST PIVOT FREELY!
INSTALL SAFETY LATCHES #8 AS SHOWN ABOVE FOR PROPER USE OF
TABLE! DO NOT SKIP THIS STEP! DO NOT OPERATE TABLE UNTIL SAFETY
LATCHES ARE INSTALLED AND ASSEMBLY IS COMPLETE!
7
7
T op View Of T able
Safety Latch #8
(in right-hand hole)
Name Panel #5
24
Figure 13
Name Panel #5
Attach safety latches #8
diagonally across from
each other.
Safety Latch #8
(in right-hand hole)