Publicidad
Idiomas disponibles
Idiomas disponibles
5.
To place the new belt begin by routing the belt around the
two outer spindle pulleys as shown in Fig. 7-8.
6.
Then route the belt around the two deck idler pulleys as
show in Fig. 7-8.
7.
Reinstall the belt keeper rod loosened earlier.
CAUTION:
may result in serious damage to your tractor's PTO
system.
8.
Remount the belt guards removed earlier.
9.
Re-install the deck making sure the belt remains routed
around the pulleys as instructed.
28
s
7— s
ectiOn
ervice
Figure 7-8
Failure to reinstall the belt keeper rod
10.
Pull the right side of the belt and place the narrow V side of
the belt into the PTO pulley. See Fig. 7-9.
Figure 7-9
11.
While holding the belt and pulley together, rotate the
pulley to the left (See Fig. 7-9). Continue holding and
rotating the pulley and belt until the belt is fully rolled into
the PTO pulley.
PTO Belt
Rotate
Pulley
Publicidad
