8
English
3.1.12
Explosion hazard! No adjustment of control valves, safety valves or other safety devices, or
tampering with their settings, is permitted.
EN
3.1.13 Scalding hazard! In the event of a pressure switch malfunction or water supply failure, the water left
inside the pump body (A4) may overheat and cause scalding when discharged.
3.1.14 Injury hazard! Do not use the appliance unattended if there is the risk of fouling.
3.1.15 Short-circuit hazard! Do not move the appliance around by pulling the plug (A12), the power cable
(A8) or other connection fixtures; use the handle (A4 b).
3.1.16 Explosion hazard! Do not allow vehicles to drive over the suction or delivery hose. Do not drag or
transport the appliance by the suction or delivery hose.
3.1.17 Injury hazard! Do not use the appliance when people or pets are in the pumped liquid, or may come
into contact with it.
3.2
SAFETY PRECAUTIONS: MUSTS
3.2.1 Short-circuit hazard! All electrical conductors must be protected from splashes of water.
3.2.2 Electrocution hazard! Only connect the appliance to an electrical power source compliant with the
relevant standards (IEC 60364-1); during start-up, the appliance may generate interference on the
electrical system. Only connect the appliance to a socket fitted with a residual current device rated at
30 mA or less. Use only electrical extension leads compliant with the relevant regulations, approved for
outdoor use and with gauge at least equal to that of the appliance's power cable. Power cables wound
onto reels must be completely unwound.
3.2.3 Danger! The appliance must never operate dry; always fill the pump body (A4) with water before
starting it. Even a short period of operation without water may cause damage.
3.2.4 Accidental switch-on hazard! Always disconnect the plug (A12) from the power socket before
carrying out any work on the appliance.
3.2.5 Danger! To guarantee the appliance's safety, the maximum temperature of the pumped liquid must
not exceed 35°C. The ambient temperature must not drop below +5°C.
3.2.6 Danger! The appliance is not designed to pump drinking water or water for human consumption.
The pumped water may be contaminated by lubricant leaks.
3.2.7 Injury hazard! Maintenance and/or repair of the appliance or electrical components must only be
carried out by specialist staff.
3.2.8 Injury hazard! Discharge residual pressure before disconnecting the hose from the appliance; to do
this, disconnect the appliance from the electricity supply and open a user outlet.
3.2.9 Injury hazard! Before use, and at regular intervals, inspect the accessories and check the
appliance's components for signs of failure and/or wear.
(Translation of the original instructions)