Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION :
DO NOT USE POWER TOOLS TO DRIVE SCREWS INTO
WOOD TOPS. HAND TIGHTEN SCREWS ONLY .
TIGHTEN SCREWS SNUG, BUT DO NOT OVER-
TIGHTEN, CAUSING SCREWS TO STRIP IN WOOD.
1.
Lay table top #1 painted side down, on a smooth, flat
surface. Use the shipping container to protect the
painted surface of the table top.
2.
Assemble the two "L " tubes and the center tubes that
make up the "U" Support and the "U" Leg. Align on
T able T op as shown in Figure 1. Note: "U" Leg is
larger and wider than the U Support. The U-
leg should be installed on the end of the table
half with the end stripe on top side
3.
Put plastic caps #13 on the end of U-leg #2.
CAUTION:
WHEN ASSEMBLING TABLE, IT IS EXTREMELY IMPORTANT THAT ALL (6)
U-CLIPS (#3) BE TURNED AS SHOWN HERE. IF U-CLIPS ARE TURNED
INCORRECTLY, YOU WILL DO IRREPARABLE DAMAGE TO YOUR TABLE
WHEN YOU ATTEMPT TO OPEN IT TO THE PLAYING POSITION.
4.
T urn the U-Clips #3 with slots toward middle of table
as shown in Figure 2. Align the holes in the U-clips #3
with pilot holes in table top assembly and secure with
twenty four screws #20 as shown.
IMPORTANT:
Be sure that slot in the six U-clips #3 all face the same
direction (toward the middle of the table with the U-
support) as shown.
3
Figure 1
This end will be the
middle of the table when
completely assembled.
2
The middle of the table is the end that
The middle of the table is the end that
The middle of the table is the end that
The middle of the table is the end that
The middle of the table is the end that
does not have the stripe on top.
does not have the stripe on top.
does not have the stripe on top.
does not have the stripe on top.
does not have the stripe on top.
13
Stripe on End
2
U-Leg
This end will be the
middle of the table when
completely assembled.
20
3
3
3
IMPORTANT: U-Leg is wider than U-support.
Make sure they are assembled exactly as
shown. If not, there will be a large gap between
table halves and table will not operate properly!
7
U-Support
All screws shown
are (#20) sheet
metal screws.
3
3
U-support
2
U-Leg
3
Figure 2
13
7
Publicidad
