Publicidad
Idiomas disponibles
Idiomas disponibles
9. Electric Ignition Surface Burners
Operation of electric igniters should be checked after range
supply line connectors have been carefully checked for leaks and
range has been connected to electric power.
a.
To check for proper lighting, push in and turn a surface
burner knob counter-clockwise to the LITE position. You will hear the igniter sparking.
b. The surface burner should light when gas is available to the top burner. Purge air from supply lines by leaving knob in the
LITE position until burner ignites. Each burner should light within 4 seconds in normal operation after air has been purged
from supply lines.
c.
Visually check that burner has lit. Once the burner lights, the control knob should be turned out of the LITE position.
d. There are separate electrodes (igniters) for each burner. Try each knob separately until all burner valves have been
checked.
10. Adjust the "LOW" Setting of Surface Burner Valve
Test to verify if LOW setting should be adjusted:
a.
Push in and turn control to any position
(keeping it push in), until burner ignites.
b. Quickly turn the knob to the LOWEST POSITION
c. If burner goes out, reset control to OFF.
d. Remove the surface burner control knob.
e.
Insert a thinbladed screwdriwer into the follow
valve stem and engage the slotted screw
inside. Flame size can be increased
(turning counterclockwise) or de creased
creased (turning clockwise) with the turn the turn of
the screw.
Adjust flame until you can quickly turn knob from the HIGHEST POSITION to LOWEST POSITION without
extinguishing the flame. Flame should be as small as possible going out.
NOTE: Air mixture adjustment is not required on surface burners.
OPERATION OF OVEN BURNERS AND OVEN ADJUSTMENTS
11. Electric Ignition Burners
Operating of electric igniter should be checked after range and supply line connectors have been carefully checked for leaks
and range has been connected to electric power.
The oven burner is equipped with an electric control system as well as an electric oven burner igniter. These control system
require not adjustment. When the oven is set to operate, current will flow to the igniter. It will GLOW similar to a light bulb.
When the igniter has reached a temperature sufficient to ignite gas, the electrically controlled oven valve will open and flame
will appear at the oven burner. There is a time lapse from 30 to 60 seconds after the thermostat is turned ON before the flame
appears at the oven burner. When the oven reaches the dial setting, glowing igniter will go off. The burner flame will go OUT in
20 to 30 seconds after the igniter goes OFF. To maintain any given oven temperature, this cycle will continue as long as the dial
is set to operate.
After removing all packing materials and literature from the oven:
Burner Flame Size
5/8"
Publicidad
