Virtual flame on/off
NZ30K7880U_DG68-00823A-01_EN+MES+CFR.indb 25
1.
Touch the POWER key for
approximately 1 second.
2.
Touch the Pause key for 3 seconds
within 10 seconds of pressing the
POWER key.
3.
Virtual flame will turn off and
will
appear in the Timer display.
4.
To change the Virtual flame setting,
repeat Steps 1 and 2.
Virtual flame will turn ON and
will
appear in the Timer display.
NOTE
To change the Virtual flame On/Off setting,
you must operate the Virtual flame On/Off
function within 10 seconds of turning the
power on.
Before using the cooktop
Use quality cookware in good condition
The cookware used with the cooktop
surface should have flat bottoms that make
good contact with the entire surface of the
Cooking Zone. Check for flatness by rotating
a ruler across the bottom of the cookware.
Be sure to follow all the recommendations
for using cookware.
Also remember to
•
Use cookware made with the correct material for induction cooking.
See "Cookware for induction cooking zones" on page 26.
•
Use quality cookware with heavier bottoms for better heat distribution. This
provides for more even cooking results.
•
The pan size should match the amount of food being prepared.
•
Do not let pans boil dry. This may cause permanent damage in the form of
breakage, fusion, or marring that can affect the ceramic cooktop. (This type of
damage is not covered by your warranty).
•
Do not use dirty pans with grease buildup. Always use pans that are easy to
clean after cooking.
CAUTION
•
The Cooking Zones may appear to be cool while turned ON and after they
have been turned OFF. The glass surface may be HOT from residual heat
transferred from the cookware and burns may occur.
•
DO NOT TOUCH HOT COOKWARE or PANS directly with your hands. Always
use oven mitts or pot holders to protect your hands from burns.
•
DO NOT SLIDE cookware across the cooktop surface. Doing so may
permanently damage the appearance of the ceramic cooktop.
English 25
9/7/2016 12:16:27 PM