Publicidad
Idiomas disponibles
Idiomas disponibles
1. Before plugging in the power cord (10), make sure the
ON/OFF switch (11) is in the "OFF" position;
2. Hold the angle grinder with both hands, one hand on the
handle (9) and the other on the auxiliary handle (12);
3. Push down the ON/OFF switch lock-on button/safety tab
and then the "ON/OFF" switch;
4. For continuous operation, push down the ON/OFF switch
lock-on button/safety tab to keep the switch locked;
5. To switch off the angle grinder, press the "ON/OFF"
switch.
Never press the spindle lock button while operating
the appliance, otherwise it may cause damage to the
angle grinder.
1. Press the lock button to prevent spindle rotation or when
you install or remove accessories;
2. To unlock the rotating spindle, release the spindle lock
button.
The angle grinder was conceived to operate over a long
period of time with a minimum of maintenance. For a
continuous and trouble-free operation, you must perform
regular cleaning and proper maintenance tasks.
Before inspecting, performing any maintenance or
cleaning, turn off the angle grinder and unplug the power
cord.
The motor will not start when the carbon brushes are worn
out. The brushes must be replaced in good time, otherwise
there will be faulty contact between the carbon brushes
and the rotor, which may cause sparks and damage to the
angle grinder. Both carbon brushes must be replaced at the
same time by two carbon brushes with the same
characteristics.
1. Loosen the fixing screws and remove the carbon brush
caps (8);
2. Lift the spring clip and remove the carbon brushes by
disconnecting the copper wire;
3. Insert the carbon brushes on the holder, connect the
copper wire and then place the spring clip over the
carbon brush;
4. Place the caps back on and fasten the screws.
Cleaning
After each use, clean all the components of the angle
grinder. Wipe the power tool with a clean, damp cloth or
blow it with low pressure compressed air.
Careful handling protects the power tool and extends its
service life.
The power tool and its ventilation slots must be kept clean.
Clean the ventilation slots regularly or whenever they
become blocked.
Storage
When not in use, store the angle grinder in a dry, clean
place, free of corrosive smoke and out of children's reach.
The packaging is made up of recyclable materials,
which you can dispose on local recycling points.
Never dispose of power tools with your household
waste!
According to the European Directive 2012/19 /EC on
electrical and electronic equipment waste and its
transposition into national law, power tools must be
collected separately and delivered to the collection sites
provided for this purpose.
You can get information regarding the disposal of the power
tool through the person in charge for recycling in your city.
Tel.:
+351 256 248 826
E-mail:
international@centrallobao.pt
Site:
www.centrallobao.pt
Publicidad
