Ø
Before Using Your Appliance
·
Remove the exterior and interior packing.
·
Check to be sure you have all the following parts:
·
1 Bake/Broil/Drip Pan
·
1 Oven Rack
·
1 Crumb Tray (NOT removable)
·
1 Instruction Manual
·
1 Bake/Broil/Drip Pan Removal Tool
·
Remove all the items inside your oven and clean the interior surface with lukewarm water using a soft
cloth.
·
Do not attempt to repair or replace any part of your oven unless it is specially recommended in this
manual.
·
This appliance requires 1200W and should be the only appliance operating on the circuit.
BEFORE YOU USE THIS OVEN FOR THE FIRST TIME: THE HEATING ELEMENTS HAVE A
PROTECTIVE COATING, WHICH MUST BE BURNED OFF BEFORE USE. TO DO THIS, OPEN
THE OVEN DOOR AND SET THE FUNCTION SELECTOR TO TOAST. LEAVE THE APPLIANCE
SWITCHED ON FOR APPROXIMATELY 15 MINUTES. IT IS IMPORTANT TO ENSURE
ADEQUATE VENTILATION DURING PERIOD AS A BURNING SMELL IS NORMAL DURING
THIS PROCESS.
Installation of Your Appliance
Select a location for the appliance. The location should be in an open area on a flat counter where the
plug will reach an outlet.
·
When positioning the appliance, it should be set on a flat, steady surface.
·
Do not block air vents. If they are blocked during operation, the oven may overheat and eventually
cause the appliance failure.
·
Keep the appliance away from hot air, steam or splashing liquids when choosing a place to locate it,
otherwise, the unit's operation may be adversely affected, causing it to break down.
·
Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
·
Plug the appliance into an exclusive properly installed grounded wall outlet. Any questions
concerning power should be directed toward a certified electrician or an authorized Avanti Products
service center.
·
Do not place anything on the top of the broiler oven and automatic toaster.
·
Keep the appliance at least 5 inches away from rear wall to ensure the proper ventilation.
Ø
Electrical Connection
·
The appliance has a polarized plug (One blade is wider than the other), to reduce the risk of electric
shock, this plug is intended to fit into the polarized outlet only one way. If the plug does not fit fully
into the outlet, reserve the plug. If it still does not fit, contact a qualified electrician. Do not attempt to
modify the plug in any way.
·
A short power cord is provided to reduce the hazards resulting from entanglement or tripping over a
longer cord. An extension cord may be used with care, however, be sure the marked electrical rating
is at least as great as the rating of this appliance. The extension cord should be positioned such that
it does not drape over the counter or tabletop where it can be pulled on by children or tripped over.
The electrical rating of this appliance is listed on the bottom panel of the appliance.
INSTALLATION INSTRUCTIONS
NOTICE
6