Descargar Imprimir esta página

Campbell Hausfeld PW2570 Instrucciones De Funcionamiento Y Lista De Piezas De Recambio página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

Pressure Washer
Maintenance
Observe regular maintenance intervals to ensure maximum
performance and life from the pressure washer . Refer to the
schedule for recommended maintenance . If you operate the
pressure washer in dusty conditions, perform maintenance
checks more often .
eNGINe OIL CHANGING INSTruCTIONS
Drain the engine oil when th engine is warm . Warm oil drains
quickly and completely .
1 . Turn the fuel valve to the OFF position to reduce the
possibility of fuel leakage .
2 . Place a suitable container next to the engine to catch the
used oil .
3 . Remove the oil filler cap/dipstick and drain the oil into the
container by tipping the engine toward the oil filler neck .
Please dispose of used motor oil in a manner that is
compatible with the envirionment . We suggest you take
used oil in a sealed container to your local recycling center or
service station for reclamation . Do not throw into the trash,
oust it on the ground, or pour it down a drain .
4 . With the engine in a level postion, fill to the upper limit
mark on the dipstick with the recommended oil .
running the engine with a low oil level
can cause engine damage.
5 . Reinstall the oil filler cap/dipstick securely .
MAINTeNANCe SCHeDuLe
Maintenance Schedule
Daily
After first 5 hours of
operation
Every 25 hours of
operation
Every 50 hours of
operation
Each 100 hours of
operation or every 3
months
www.chpower.com
Action Needed
• Check water inlet screen and
filter .
• Check engine oil levels. Fill as
necessary .
• Check gasoline level. Fill as
necessary .
• Change engine break-in
oil . Use SAE30 or 10W-30
detergent oil .
• Change oil if operating under
heavy load or high ambient
temperature .
• Clean or replace paper air
cleaner cartridge . Tap gently
to remove dirt .
• Change oil.
• Replace spark plug.
• Replace paper air cleaner
cartridge .
• Change engine oil.
Oil filler neck
Figure 12 – Oil Drain Location
PuMP OIL CHANGING INSTruCTIONS
Changing or refilling the oil in the pump requires removal of
the pump from the engine and should not be required unless
oil has leaked out due to worn or damaged oil seals in the
pump . If oil has leaked out of the pump, bring the pressure
washer to a certified Campbell Hausfeld service center for
repair .
TeCHNICAL AND CONSuMer INFOrMATION
vertical Oriented Pressure Washers
engine Oil Type
engine Oil Capacity
Honda Engines
engine Fuel Capacity
Honda Engines
Pump Oil Type
Wobble Pumps
Pump Oil Capacity
Vertical Wobble Pumps
Pump Detergent Suction
Water to detergent ratio
Water Supply requirements
Minimum inlet pressure
Maximum inlet pressure
Maximum inlet temperature
Minimum inlet flow rate
Inlet garden hose size
Maximum inlet garden hose length 50 feet
10
Oil filler cap/
dipstick
Upper limit
SAE 10W-30
SAE 30W (Above 60° F)
18 .5 fl . oz .
0 .29 gal
SAE30W
non-detergent oil
2 .7 fl . oz .
8 to 1 (12% detergent)
20 psi
100 psi
100° F
5 gpm
5/8 inch I .D .

Publicidad

loading