Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting to the GSR sensor
The GSR sensor needs to form a strong connection to
the skin in order to work properly. For better results, the
skin should be clean and wet. Attached are two probes
with Velcro finger connectors. While conducting
experiments, remain as still as possible.
1. Clean the bases of two fingers on the same hand
with alcohol and wet them a little with water.
2. Wrap the Velcro connectors around the two bases of
the fingers, securing as tightly as possible without
causing discomfort.
3. For best results, ensure the flat metal piece on each
Velcro connector is located on the underside of each
finger.
4. Attach both the white and the black snap connectors
(located on the end of the wire) to the Velcro finger
connector by snapping to the exposed metal nub.
Note: It does not matter which connector is attached
to which finger.
5. You are now properly connected to the GSR sensor.
V2018.01
19
Home
English
Publicidad
