Glacier bay FS6A0071CP Guía De Instalación Y Cuidado página 8

Operation
1
Flushing and checking for leaks
IMPORTANT: After installation is complete, remove the
in the aerator.
Ensuring the handle is in the off position, turn
on the water supply and check for leaks. If you
discover any leaks, check your connections to
ensure they are installed properly.
Use a coin to remove the aerator (B) from the
faucet (A). Lift the handle to allow the water to
run for at least one minute. This flushes away any
debris that could cause damage to internal parts.
Turn off the water and reinstall the aerator and
housing (if applicable).
Care and Cleaning
To clean, wipe down with a damp cloth and towel dry.
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
Troubleshooting
NOTE: Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
Problem
There are leaks from the handle.
The aerator leaks or has a reduced
water flow.
The sink drain at the base of the
sink is leaking.
The water will not shut off
completely.
Do not lose the gasket
Possible Cause
The locking nut is loose.
The O-ring on the cartridge is
dirty or damaged.
The aerator is dirty or mis-fitted.
The cartridge may be clogged.
The sink surface is rough or
irregular.
The locking nut is loose or
cartridge is not positioned
correctly.
8
1
A
B
Solution
□ Tighten the locking nut.
□ Clean or replace the O-ring.
□ Remove the aerator and check for
debris.
Remove cartridge and check for
debris.
Ensure the aerator is properly
installed.
□ Apply additional silicone sealant to
the beveled side of the drain flange.
□ Apply silicone sealant to the beveled
side of the rubber washer on the
drain body.
□ Retighten and test for leaks.
Remove cartridge and reset to ensure
proper position.
Tighten lock nut.
Clean or replace.
1