Descargar Imprimir esta página

Yard force YF22-3N1SPVS-SC Manual De Uso Y Cuidado página 19

Publicidad

Idiomas disponibles

Idiomas disponibles

EMPTYING THE GRASS BAG
As soon as grass clippings start to trail the lawn mower, it is time to empty the grass bag.
NOTE: Before taking off the grass bag, switch off the engine and wait until the blade has come
to a stop.
1. To take off the grass bag, use one hand to lift up rear chute flap and the other to grasp the grass bag
handle. The rear chute flap automatically falls down after removing the grass bag and closes off the rear
chute opening.
2. Empty the grass debris in the grass bag, and reinstall the grass bag.
NOTE: If any grass residue is caught in the discharge chute, clean it using a brush. Do not remove
grass debris in the mower casing or on the blade by hand or with your feet. Instead, use suitable
tools such as a brush or broom. To ensure that the cut grass can be collected into grass bag, the
discharge opening and inside the mower casing must be cleared of any blockage.
WARNING: Before performing any maintenance or cleaning work, switch off the engine and wait
until the blade has come to a stop.
CLEANING
GENERAL CLEANING
The lawn mower should be cleaned thoroughly every time after it has been used. Always clean your lawn
mower immediately after use.
Do not allow grass cuttings and other debris to become dry and hard on any of the mower surfaces.
Dried grass remnants and dirt may impair the mowing operation.
Check that the grass chute is free of any residual grass. Remove any such residue. Check the underside of
the lawn mower and the blade mount. When checking, tilt the lawn mower onto its left side (opposite the oil
filler neck).
NOTE: Before placing the lawn mower on its side, fully drain the fuel tank using a gas extraction
pump.
Do not tilt the lawn mower by more than 90 degrees.
MAINTENANCE OF THE SPARK PLUG
As shown in Fig. 20
Hotline: 1-866-902-9690
OPERATION
STORING AND MAINTENANCE
Fig. 20
0.027"- 0.033"
19

Publicidad

loading