ims PRO PULSEMIG 320 C Manual De Instrucciones página 38

SEMI-AUTOMATIC WELDING (MODE MIG / MAG) - GMAW
THE SETTINGS OF THE MIG / MAG PROCESS
Settings Designation
Torque
material/gas
Wire diameter
Welding process
ModulArc
(Arc Module)
Trigger behaviour
Tack welding mode
Settings
Energie
MIG-MAG WELDING
• GMAW/MIG-MAG Manual
Settings Designation
Wire speed
Voltage
Self
Pre-gas
Post gaz
Access to some welding parameters depends on the selected display mode: Settings/User Level: Easy, Expert, Advanced.
38
PULSEMIG 320 C
Adjustable settings Manual
- Fe Ar CO2 18%
- Al Mg 5 Ar 100%
- HARDFACE Metal
- etc
Ø 0.6 > Ø 1.6 mm
- Manual
- Dynamic STD
- Pulse
- Cold Pulse
OFF - ON
2T, 4T
Spot, Delay
Thickness
Speed
Current
Hold
Thermal coeff.
Adjustable
settings
1 - 22m/min Quantity of filler metal deposited and indirectly the welding intensity.
10 - Umax Sets the welding power.
Smoothes more or less the welding current. To be adjusted according to the welding
-4 > +4
position.
0 - 25 secs. Torch purge time and to protect the area with gas before ignition
Duration for which gas is released after the arc has stopped. It protects the weld pool
0 - 25 secs.
and the electrode against oxidisation when the metal is cooling down.
Dynamic STD
Pulse
(Standard)
Choice of the material to be welded.
Synergic welding parameters
Choice of wire diameter
Enables or not the modulation of the welding
current (appearance of a TIG weld bead)
Choice of trigger welding management mode.
Choice of scoring mode
Choice of the main parameter to be displayed
(Thickness of the part to be welded, wire
speed, average welding current).
See chapter «ENERGY MODE» on pages
following.
Description & advice
EN
Recommendations