Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instructions
Installing your Dual fuel Range
NOTE
•
IMPORTANT: Please read the following instructions, as well as the Important
Safety Instructions section at the front of this manual, completely and
carefully BEFORE installing and/or operating the gas range. Improper
installation, adjustment, service, or maintenance can cause personal injury or
property damage.
Step 1. Unpack the range
Remove all packaging materials. Failure to remove packaging materials could
result in damage to the appliance.
Inventory all loose parts against the 'Parts supplied' overview on page 18.
Check for shipping damage and/or missing parts. Any damage and/or missing
parts should be reported to your local retailer.
Install_DOP36P86DLS_DG68-01106E-00_EN+MES+CFR.indb 19
To order parts or accessories, contact
•
your local retailer or refer to the last
page.
•
To ensure proper installation, we
strongly recommend that you hire a
professional installer.
Step 2. Meeting electrical connection requirements
CAUTION
For personal safety, do not use an extension cord with this appliance. Remove
house fuse or open circuit breaker before beginning installation.
This appliance must be supplied with the proper voltage and frequency, and
connected to an individual properly grounded branch circuit, protected by a circuit
breaker or fuse having amperage as specified on the rating plate. The rating plate
is located above the drawer on the oven frame.
We recommend you have the electrical wiring and hookup of your range
connected by a qualified electrician. After installation, have the electrician show
you where your main range disconnect is located.
Check with your local utilities for electrical codes which apply in your area. Failure
to wire your oven according to governing codes could result in a hazardous
condition.
If there are no local codes, your range must be wired and fused to meet the
requirements of the National Electrical Code, ANSI/NFPA No. 70–Latest Edition.
You can get a copy by writing:
National Fire Protection Association
Batterymarch Park
Quincy, MA 02269
Effective January 1, 1996, the National Electrical Code requires that new
construction (not existing) utilize a 4-conductor connection to an electric range.
When installing an electric range in new construction, follow Steps 2 and 3 for
4-wire connection.
You must use a 3-wire or 4-wire, single-phase A.C. 208Y/120 Volt or 240/120 Volt,
60 hertz electrical system.
If the electrical service provided does not meet the above specifications, have a
licensed electrician install an approved outlet.
Use only a 3-conductor or a 4-conductor UL-listed range cord. These cords may be
provided with ring terminals on wire and a strain relief device.
A range cord rated at 40 amps with 125/250 minimum volt range is required.
English 19
2020-07-01 오후 3:44:08
Publicidad
