Makita GRU01 Manual De Instrucciones página 11

ASSEMBLY
WARNING:
Always be sure that the tool is switched off
and battery cartridge is removed before carrying out any work
on the tool. Failure to switch off and remove the battery cartridge
may result in serious personal injury from accidental start-up.
WARNING:
Never start the tool unless it is completely
assembled. Operation of the tool in a partially assembled state
may result in serious personal injury from accidental start-up.
Installing the handle
1. Attach the upper and lower clamps on the damper.
2.
Put the handle on the upper clamp and fix it with
hex socket head bolts as illustrated.
1
2
► 1. Hex socket head bolt 2. Handle 3. Upper clamp
4. Damper 5. Lower clamp 6. Spacer
CAUTION:
Do not remove or shrink the spacer. Doing
so lose the balance of the tool and may cause personal injury.
Attaching the barrier
For the loop handle model only (country specific)
If the barrier is included in your model, attach it to the
handle using the screw on the barrier.
► 1. Barrier 2. Screw
CAUTION:
After assembling the barrier, do not
remove it. The barrier works as a safety part to prevent
you from contacting the cutting blade accidentally.
6
3
4
5
1
2
Hex wrench storage
CAUTION:
Be careful not to leave the hex
wrench inserted in the tool head. It may cause
injury and/or damage to the tool.
When not in use, store the hex wrench as illustrated to
keep it from being lost.
► 1. Hex wrench
For the loop handle model, the hex wrench can also be
stored on the handle as illustrated.
► 1. Hex wrench
Correct combination of the cutting
tool and the protector
CAUTION:
Always use the correct combi-
nation of cutting tool and the protector. A wrong
combination may not protect you from the cutting tool,
flying debris, and stones. It can also affect the bal-
ance of the tool and result in an injury.
Cutting tool
Nylon cutting head
11 ENGLISH
1
1
Protector