Descargar Imprimir esta página

Clarke EX40 18LX Instrucciones De Uso página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

SPRAY NOZZLE MAINTENANCE
Remove the Maintenance Spray Nozzle (A) once a week. See Figure 8. Turn the nozzle 1/4 turn counterclockwise to remove. Soak the nozzle
overnight in vinegar to remove chemical deposits. Do not use pins, wire, or similar to clean nozzle as this could destroy spray pattern.
SOLUTION FILTER MAINTENANCE
Once a week (or more often if necessary), inspect and clean the Solution Filter (10). Drain the recovery and solution tanks. Lift the recovery tank from
the machine and set it off to the side. See Figure 4. Keep the solution hose connected and turn the Filter Assembly (E) 1/4 turn counterclockwise to
loosen. Pull the fi lter assembly straight up and out of the solution tank. Reinstall after cleaning by following steps in reverse order.
POWER CORD MAINTENANCE
Once a week (or more often if necessary), check the power cord for cracked or damaged insulation, exposed wires in the cord or plug, and damaged
or missing ground pin. Replace damaged cord or plug immediately.
POWER BRUSH MAINTENANCE
Check the brush daily. Remove any built-up string, hair or carpet fi bers. When the machine is not in use it should be placed in the storage position.
This will prevent the brush from taking a set which will increase the brush life and maintain the performance of the brush.
REMOVING THE BRUSH
CAUTION!
Turn the power switch off (O) and unplug the machine, before changing the brushes.
1
Empty both the recovery and solution tanks. Open the recovery tank dome lid. Lift the recovery tank from the machine and set it off to the side.
2
Place the Handle Assembly (23) into a vertical position and tip the machine over onto its back.
3
See Figure 8. Rotate the brush until the Drive Lug (B) is in a position where the fi ns on the drive lug are parallel to the fl oor.
4
Grab the brush at the end with the Brush Retainer Clip (C) and pull straight out.
5
Install a new brush at the drive lug end fi rst then push in the other brush end in until it snaps into the retainer clip.
FIGURE 8
3.
9/2015
INSTRUCTIONS FOR USE
4.
C
B
A
56091181 - EX40 16ST, EX40 18LX
ENGLISH - A
A - 15

Publicidad

loading

Este manual también es adecuado para:

Ex40 16st5626550556265504