Broan EW4330SS Manual De Instalación, Uso Y Cuidado página 7

9. DUCT CONNECTION
v
ertIcally DucteD INstallatIoN
Slide a 6" round metal duct section over the adapter/damper on the hood up to the roof
cap. Use metal foil duct tape to seal the joint.
h
orIzoNtally DucteD INstallatIoN
Measure and install 6" round metal ductwork to wall cap and 90° elbow over duct collar,
then install the 90° elbow over the adapter/damper on the hood. Use metal foil duct tape
to seal the joints.
N - :
oN DucteD INstallatIoN
Remove and discard the damper flaps from the adapter on top of hood. Measure the length
of 6" round flexible duct (included in the non-duct kit) required from the top of the hood to
the plenum. Slide the 6" round flexible metal duct over the adapter on the hood. Use metal
foil duct tape to seal the joint.
:
:
HJ0246
HJ0247
HJ0248
7