Before installation
Read through the following instructions before installing the dryer, and keep this manual
for future reference.
WARNING
Certain internal parts are intentionally not grounded and may present a risk of electric
shock only during servicing. Service Personnel - Do not contact the following parts while
the appliance is energized: Control board, Motor, Drain pump.
Key installation requirements
• A grounded electrical outlet.
• A power cord for electric dryers (except
in Canada).
• A sink or drain pipe if you want to
drain the water captured during drying
through the supplied long drain hose.
(See page 20.)
Location considerations
• Adequate clearances between the dryer
and adjacent walls or other surfaces.
• Adequate air circulation for ventilation.
• Away from water and weather.
WARNING
• Keep the dryer area clear of
combustible materials, gasoline, and
other flammable vapors and liquids.
• Do not install other fuel-burning
appliances around or in the same place
as the dryer.
• Place dryer at least 18 in (460 mm)
above the floor for a garage installation.
DV6850N_DC68-03650E-05_EN.indd 9
WARNING
Remove the door from all discarded
appliances to prevent a child from
suffocating.
Alcove or closet installation
Minimum Clearance for stable operation:
Sides
Top
Rear
Front
The closet front must have two
unobstructed air openings for a combined
minimum total area of 72 in² (465 cm²)
with 3" (7.6 cm) minimum clearance on
the top and bottom. A louvered door with
equivalent space clearance is acceptable.
1 in. (25 mm)
1 in. (25 mm)
2 in. (50 mm)
1 in. (25 mm)
English 9
2019/8/7 17:41:29