Liberty Pumps PDC-230 Manual De Instalación página 6

Operator Controls – On Alarm Backup Power
The operator has access to front – panel push – button controls to change the horn enable status, to test the alarm
circuits, and to manually run the pumps.
Control Push- Existing Condition(s)
button
*HORN ENABLE HORN DISABLE
/ DISABLE indicator is blinking
HORN DISABLE
indicator is OFF
ALARM TEST
MANUAL RUN
*Horn disable LED is on PDC-115 and PDC230 units only. Outdoor units, PDCW-115 and PDCW-230, have an alarm
silence switch on the exterior of the unit.
Front-Panel Indicators – On Alarm Backup Power (9 volt battery)
The horn and LED indicators on the front panel, are used to show various conditions in the controller. Each indicator is
described below.
Indicator Indicator State
POWER Off
LED
Blinking
*Horn Off
Disable LED Blinking
Alarm LED Off
Blinking
PUMP 1 OFF
LED
PUMP 2 OFF
LED
HORN OFF
BEEPING
*Horn disable LED is on PDC-115 and PDC230 units only. Outdoor units, PDCW-115 and PDCW-230, have an alarm
silence switch on the exterior of the unit.
Action When Pressed
Horn Disable indicator will stop blinking and the horn will be enabled.
Horn disabled indicator will start blinking and the horn will be disabled for
12 hours. After 12 hours, the indicator will turn off automatically and the
horn will then be enabled
Horn, alarm indicator, and auxiliary relay will turn on. They will remain in
that state until the button is released
The button press is ignored due to lack of primary power.
Description
Power is off to the panel and the backup alarm battery is dead.
Primary power to the panel is Off; the panel is on alarm backup power. Pumps will
NOT run. See the section on Alarm Backup Power.
Horn operation is Enabled. The horn Will beep on and off in an alarm condition.
Horn operation is Disabled.
There is no alarm condition.
An alarm condition is active.
The Pump 1 indicator will always be OFF when on alarm backup power.
The Pump 2 indicator will always be OFF when on alarm backup power.
No alarm condition is present.
An alarm condition is present.
©Copyright 2013 Liberty Pumps Inc. All rights reserved 6