Assembly; Pivot Bolt; Vertical Stabilizer And Rubber Feet - Delta 36-267 Manual De Instrucciones

Tools Required for Assembly (not included):
Phillips screwdriver, socket set, and an
adjustable wrench.

PIVOT BOLT

1. Lay the stand on its side.
2. Pull the rear folding support (A) toward the
handle tube openings (B) in order to align the
holes in the rear folding support and front
folding support.
3. Insert an M12 x 110mm hex bolt (C) through
the front folding leg. Place an M12 washer (D)
between the front and rear supports and feed
the bolt through the washer and rear support.
4. Secure with an M12 hex nut. The nut should be
snug but not over-tight.
5. Place the stand upright. The holes in the
supports on the opposite side should be nearly
aligned. Repeat Steps 3 and 4 to secure other
side.
VERTICAL STABILIZER AND
RUBBER FEET
1. Place the stand on its side.
2. Insert the vertical stabilizer (A) into the ends
of the rear folding supports (B) with the end of
the stabilizer angling up. Align the holes in the
stabilizer and supports.
3. Attach the larger rubber feet (C) to the bottom of
the vertical stabilizer by feeding an M10 x 55mm
hex bolt through the bottom of the feet. Secure
with an M10 hex nut, remembering to rotate it
clockwise to tighten.
4. Attach the smaller rubber pads (D) to the end of
the vertical stabilizer using two M6 x 50mm pan
head bolts and M6 locknuts.

ASSEMBLY

6
C
D
B
D
B
Align holes
A
A
C