Attaching Miter Saw To The Stand; Using A Mounting Platform - Delta 36-267 Manual De Instrucciones

ATTACHING THE MITER SAW TO THE STAND
NOTE: This stand comes with four M8 x 55mm bolts
with M8 washers and hex nuts. If your saw requires a
different number or size of mounting bolt, use hardware
that will properly secure your saw. Make sure bolt ends
do not extend above the saw table.
NOTE: The DELTA 36-267 miter saw stand is designed
to work with virtually all miter saws. In the event that
the mounting holes on the saw do not line up with the
slots in the mounting brackets, skip to the next section,

"Using a Mounting Platform"

1. Ensure the saw is disconnected from the power
source and the blade and arm are locked in the
down position.
2. With both mounting brackets attached to the rails,
lock one of the mounting brackets in position by
turning the lock knob (A) clockwise.
3. Place the saw on top of the mounting brackets so
that the mounting holes in the saw (B) align with the
USING A MOUNTING PLATFORM
Should the existing mounting holes in your saw not fit
the slots in the mounting brackets, it will be necessary
to mount a wooden platform to the brackets then mount
the saw to the platform.
The platform can be made from any rectangular or
square piece of wood scrap that is at least ½-inch thick
and large enough to extend beyond the saw's base by at
least an inch.
1. Unlock and remove mounting brackets from the rails.
Place them upside down on the top of board so that
they are centered top to bottom and aligned with the
edge of the board.
2. Use a pencil to mark the midpoint in the top and
bottom slots on each bracket.
ASSEMBLY
NOTE: The exact location of the mounting holes may
vary from saw to saw. Figure 6 is given as an example.
4. Feed an M8 x 55mm hex bolt (C) fitted with an M8
5. Adjust the other bracket under the saw so that
6. Repeat Step 4 to secure saw to second mounting
E
B
D
C
3. Remove the brackets and drill a ¼-inch hole at each
mark.
4. Place the saw on the platform so that it is centered
on the board. Mark the mounting holes with a pencil.
5. Remove the saw and use a
the holes in the platform.
6. Mount the saw to the board using bolts, washers and
nuts (not provided).
7. Follow Steps 4-6 in above section (Attaching the
Miter Saw to the Stand) to secure the platform to the
brackets.
8
slots in the stationary bracket.
washer (D) up through the slots in the bracket and
through the mounting holes in the saw. Secure
with an M8 hex nut (E).
the brackets slots align with the saw's mounting
holes. Lock bracket in place by turning lock knob
clockwise.
bracket.
A
5 / - inch drill bit to drill
16