Note: Remove all packaging, including straps, before using the griddle.
WARNING: IMPORTANT BEFORE LIGHTING
Inspect the gas supply hose prior to turning the gas "ON". If there is evidence of cuts, wear, or abrasion, it must be
replaced prior to use. Do not use the grill if the odor of gas is present. Only the pressure regulator and hose assembly
supplied with the unit should be used.
Never substitute regulators and hose assembly for those supplied with the grill. If a replacement is necessary, contact the
manufacturer for proper replacement. The replacement must be that specified in the manual.
WARNING: Always keep your face and body as far away from the burner as possible when lighting.
GENERAL USE OF THE MAIN BURNER
Each main burner is rated at 12,000 BTU/hr. The main grill burners encompass the entire cooking area and are side
ported. The burner knobs are located on the control panel. Each ignition setting is labeled on the control panel.
Main Burner
Each burner assembly is adjusted prior to shipment; however, variations in the local gas supply may
make minor adjustments necessary.
Do not attempt to light the grill if odor of gas is present. Call for service 1-855-634-2627.
Check all gas connections before each use.
MAIN BURNERS
TO LIGHT THE MAIN BURNERS
1.
Turn ON the gas tank valve.
2.
Push and turn corresponding burner control knob to the
pressing the ignition button to light the burner.
3.
Once the burner is lit, release the ignition button and knob.
If burner does not light up, turn the knob to ○ and repeat the lighting
4.
procedure.
TO MATCH LIGHT THE BURNER
1.
If the burner will not light after several attempts then the
burner can be match lit, before using the match allow 5
minutes for any accumulated gas to dissipate.
2.
Clip a paper match on one end of the lighting rod.
3.
Light match.
4.
Hold lighting rod and insert lighted match right next to the
burner ports or ceramic file.
5.
Push and turn the designated control knob to
6.
Burner should ignite immediately.
9
while
.