Descargar Imprimir esta página

Technics SL-G700M2 Instrucciones Básicas página 7

Ocultar thumbs Ver también para SL-G700M2:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 94
(Inside of product)
(Produktets innside)
For the United Kingdom and Ireland customer
Caution for AC Mains Lead
(For the AC mains plug of three pins)
For your safety, please read the following text carefully.
This appliance is supplied with a moulded three
pin mains plug for your safety and convenience.
A 10-ampere fuse is fitted in this plug.
Should the fuse need to be replaced please ensure
that the replacement fuse has a rating of 10-ampere
and that it is approved by ASTA or BSI to BS1362.
Check for the ASTA mark
on the body of the fuse.
If the plug contains a removable fuse cover you must
ensure that it is refitted when the fuse is replaced.
If you lose the fuse cover the plug must not be
used until a replacement cover is obtained.
A replacement fuse cover can be purchased from
your local dealer.
Before use
Remove the connector cover.
How to replace the fuse
The location of the fuse differ according to the type
of AC mains plug (figures A and B). Confirm the AC
mains plug fitted and follow the instructions below.
Illustrations may differ from actual AC mains plug.
Disposal of Old Equipment and Batteries
Only for European Union and countries with recycling systems
These symbols on the products, packaging, and/or accompanying documents mean that used
electrical and electronic products and batteries must not be mixed with general household
waste.
For proper treatment, recovery and recycling of old products and used batteries, please take
them to applicable collection points in accordance with your national legislation.
By disposing of them correctly, you will help to save valuable resources and prevent any
potential negative effects on human health and the environment.
For more information about collection and recycling, please contact your local authority.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national
legislation.
Note for the battery symbol (bottom symbol):
This symbol might be used in combination with a chemical symbol. In this case it complies with
the requirement set by the Directive for the chemical involved.
or the BSI mark
1. Open the fuse cover with a screwdriver.
Figure A
2. Replace the fuse and close or attach the fuse cover.
Figure A
Fuse
(10 ampere)
NORSK
ADVARSEL
Produkt
• For å redusere faren for brann, elektrisk støt eller
skade på apparatet :
- Utsett ikke produktet for regn, fukt, drypping eller sprut.
- Ikke plasser objekter som er fylt med væske, som vaser, på apparatet.
- Bruk anbefalt tilbehør.
- Fjern ikke deksler.
- Reparer ikke denne enheten selv, overlat service
til kvalifisert servicepersonell.
Vekselstrømnett
• Nettstøpselet er trukket ut fra denne enheten.
Installer denne enheten slik at nettstøpselet
umiddelbart kan trekkes fra stikkontakten.
FORSIKTIG
Produkt
• Dette produktet anvender en laser. Betjening av kontroller
eller justering eller andre inngrep enn de beskrevet i
denne bruksanvisning kan føre til farlig bestråling.
• Plasser ikke åpen ild, slik som levende lys, oppå apparatet.
• Denne enheten er beregnet for bruk i moderate og tropiske klimaer.
Plassering
• For å redusere faren for brann, elektrisk støt eller skade på apparatet :
- Ikke plasser apparatet i en bokhylle, et innebygget kabinett eller
et annet lukket sted. Pass på at produktet er godt ventilert.
Figure B
Fuse cover
Figure B
Fuse
(10 ampere)
(07)
07

Publicidad

loading