EAS ELECTRIC EMF1453 Manual De Instrucciones página 34

4.2 Bulb replacement
This procedure can only be carried out by professionals.
5. CLEANING
5.1 Defrosting
Please note that this unit does not have an automatic defrosting system.
Use a plastic scraper or spatula to remove frost from the evaporator. Do not
use sharp metal objects.
5.2 Cleaning the interior and exterior of the unit
 Dust behind the refrigerator and the floor should be cleaned regularly to
improve the cooling effect and save energy.
 Check the door rubber regularly to make sure that there is no debris or
dirt left on the door. Wipe it with a damp cloth of soap and water or
diluted detergent.
 The inside of the refrigerator should be cleaned often to avoid odours.
 Disconnect the refrigerator from the power supply before cleaning the
interior, and remove all food, beverages, shelves and drawers, etc....
 Use a soft cloth or sponge to wipe the inside of the refrigerator with a
solution of warm water and two tablespoons of baking soda. Then rinse
and wipe it with a cloth. After cleaning, open the door and allow it to air
dry before plugging it back in.
 For areas that are more difficult to clean (such as narrow slots, corners or
nooks and crannies), it is advisable to clean them often with a soft cloth or
brush and, if necessary, using other tools (such as a toothpick) to ensure
that contaminants and bacteria do not build up.
 Do not use soap, detergent, powders or sprays as these may cause odours
inside the refrigerator or contaminate food.
Clean the bottle rack frame, shelves and drawers with a soft cloth

dampened with soap and water or diluted detergent. Wipe dry with a soft
cloth or allow to air dry.
 Clean the outside surface of the refrigerator with a soft cloth dampened
with soap and water or detergent, then wipe dry with a cloth.
Do not use hard brushes, aluminium scouring pads, metal brushes,

abrasives (such as toothpaste), organic solvents (such as alcohol, acetone,
etc.), boiling water, acid or alkaline solutions, or anything else that may
damage the exterior or interior surface of the refrigerator. Boiling water or
organic solvents such as benzene may deform or damage plastic parts.
 Do not rinse directly with water or other liquids during cleaning to avoid
short circuits or affecting the electrical insulation by immersion.
15 V.2