Hart HTSNW00 Manual Del Operador página 8

ASSEMBLY
JOINING THE POWER HEAD TO THE SNOW
THROWER ATTACHMENT
See Figure 2.
WARNING:
Never attach or adjust any attachment while power
head is running. Failure to stop the engine or motor
could cause serious personal injury.
The snow thrower attachment connects to the power head
by means of a coupler device.
 Remove the spark plug wire, disconnect from the power
supply, or remove the battery pack.
 Remove the hanger cap from the attachment.
 Loosen the knob on the coupler of the power head shaft.
 Push in the button located on the snow thrower
a ttachment. Align the button with the guide recess on the
power head coupler and slide the two shafts together.
Rotate attachment shaft until button locks into the posi-
tioning hole.
OPERATION
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
NOTE: If the button does not release completely in the
positioning hole, the shaft is not locked into place. Slightly
rotate from side to side until the button is locked into
place.
 Tighten the knob securely.
WARNING:
Be certain the knob is fully tightened before operating
equipment. Check it periodically for tightness during
use to avoid serious injury.
REMOVING THE ATTACHMENT FROM THE
POWER HEAD
 Stop the engine or motor and remove the spark plug wire,
disconnect from the power supply, or remove the battery
pack.
 Loosen the knob.
 Push in the button and twist the shafts to remove and
separate ends.
NOTICE:
Before each use, inspect the entire product for dam-
aged, missing, or loose parts such as screws, nuts,
bolts, caps, etc. Tighten securely all fasteners and caps
and do not operate this product until all missing or
damaged parts are replaced. Please contact customer
service or a qualified service center for assistance.
APPLICATIONS
You may use this product for the purpose listed below:
 Removing snow from desired areas such as driveways
and sidewalks
USING THE SNOW THROWER ATTACHMENT
See Figure 3.
WARNING:
Engine housing on gas power heads may become hot
during snow thrower operation. Do not rest or place
your arm, hand, or any body part against the engine
housing during snow thrower operation. Only hold the
snow thrower as shown in figure 3 with all body parts
clear of engine housing. Extended contact with the
engine housing can result in burns or other injuries.
6 – English