HIKOKI NT 1865DA Instrucciones De Manejo página 16

English
<NT1850DBSL>
18 Gauge brad nails
(straight)
STANDARD ACCESSORIES
In addition to the main unit (1 unit), the package contains the
accessories listed on page 410.
Standard accessories are subject to change without notice.
APPLICATIONS
<NT1865DBAL, NT1865DBSL, NT1865DA>
○ Nailing as fi nishing process for areas around the doors,
windows as well as edgings.
○ Securing the bottom of drawers. Making various cases
and cabinets.
<NT1850DBSL>
○ Cabinet and picture frame assembly, furniture trim.
○ On-site and mobile home trim and molding.
Min.
1.9 mm
1 mm 1.25 mm
Excluding nails that measure 35 mm in length
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect to the power source. (Fig. 3)
When charging the battery from an AC power source
○ Connect the charger's power cord to the receptacle.
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red (At 1- second intervals).
CAUTION
Do not use the electrical cord if damaged. Have it
repaired immediately.
2. Insert the battery into the charger.
Firmly insert the battery into the charger until the line is
visible, as shown in Fig. 3.
Lines are not displayed on the UC18YFSL. Make sure
that the battery is set fi rmly in place.
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light up continuously
in red.
When the battery becomes fully recharged, the pilot lamp
will blink in red. (At 1-second intervals) (See Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or the
rechargeable battery.
16
Max.