Danby DAR033A1BSLDBO Manual Del Propietário página 4

OPERATING INSTRUCTIONS
LOCATION
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth.
• Place the appliance on a fl oor that is strong
enough to support it when it is fully loaded.
• Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• This appliance is 45 cm (17.7 inches) wide
by 84 cm (33.1 inches) high by 51 cm (20.1
inches) deep. Make sure that you leave the
minimum amount of space between the
appliance and all surrounding walls and vents.
• Allow 12.7 cm (5 inches) of space between the
back, sides and top of the appliance and all
adjacent walls.
• This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
• This appliance can be used outdoors. The
recommended ambient operating temperature is
between 7°C - 43°C (45°F - 109°F) when not in
direct sunlight.
FEATURES
1. Adjustable Shelves
2. Defrost Water Outlet
3. CANSTOR™ Door Liner
4. Bottle Rack
5. Magnetic Gasket
6. Leveling Leg
7. Thermostat Dial: not shown, located on inner
ceiling of the appliance.
1
2
3
4
6
5
LEVELING INSTRUCTIONS
There is an adjustable leg on the bottom of the
appliance that can be turned up or down to ensure
that the appliance is level.
1. Turn the leveling leg counter-clockwise until
the top of the foot is touching the bottom of the
cabinet.
2. Slowly turn the leveling leg clockwise until the
appliance is level.
CASTER INSTALLATION
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Unscrew the leveling foot to remove it. Use a
screwdriver to remove the three solid feet.
2. Match the screw holes on the bottom of the ap-
pliance with the pre-drilled holes on the casters.
Use a screwdriver to screw the casters in place.
The two casters with brakes should be installed
at the front of the appliance.
1
2
3