Publicidad
Idiomas disponibles
Idiomas disponibles
REDUCED FLAME GAS COCK ADJUSTMENT
1. Please use driver with special head for
removed and install nozzle as (Figure 4)
2. Please remove nozzle (Figure 5) from
burner with special nozzle driver and install
new nozzle (Figure 6)
Figure 4
REDUCED GAS FLOW RATE SETTING FOR HOB TAPS
Figure 7
Figure 8
To adjust your oven acc. to the gas type, make the adjustment for reduced
flame carefully by turning with a small screwdriver as shown below on the
screw in the middle of the gas cocks as well as nozzle changes. (Figure 7 and 8)
Figure 5
1. Ignite the burner that is to be adjustment and
turn the knob to the reduced position.
2. Remove the knob from the gas tap.
3. Use an appropriately sized screwdriver to adjust
the flow rate adjustment screw. For LPG (Butane-Pro
pane) turn the screw clockwise. For the naturel gas,
you should turn the screw counter- clockwise once.
"The normal length of a straight flame in the
reduced position should be 6-7 mm."
4. If the flame is higher then the desired
position, turn the screw clockwise. If it is smaller
turn anticolockwise.
5. For the last control, bring the burner both
to higt-flame and reduced positions and check
whether the flame is on or off.
Depending on the type of gas tap used in your
appliance the adjustment screw position may vary.
GB
Figure 6
12
Publicidad
