Maintenance Items - Resfriar S7i Manual Del Propietário

• LACK OF WATER: The control panel has a sensor to detect lack of
water inside the tank. When the water level is lower than minimum,
the yellow led (2) starts blinking, informing the user needs to refill
2
the water tank. After filling it, the water function will automatically be
activated.
Note: When lack of water is detected, water function stops
automatically.
• FAN SPEED: R7i control panel has 10 speeds controlled by buttons (7)
(off/decrease) and (8) (on/increase). The fan is factory set to start at the
8
minimum speed when pressing the button (8). You will note that the
fan reaches its maximum speed levels when you hear a longer beep
coming from the panel.
• REMOTE CONTROL (OPTIONAL): This device has all the panel
functions as detailed above plus an exclusive command (9) to turn on/
off the fan.
Note: If any function doesn't work using the remote control,
verify the battery charge and if necessary, replace it. When
replacing, use the CR.2025 battery model.
18
7
8
9
3. Important Parts for Maintenance
• FAN: Located in the center of the base, it is responsible for the
ventilation, getting the air from outside and carrying it to inside of the
cabin, already cooled. Its carbon brushes must be inspected every six
months and, if necessary, replaced. It is suggested to change the fan
every two years.
• STRAW FILTER SET: Located inside the water tank, it filters dirt, dust
and insects. It humidifies the air coming from outside, through an
evaporation process where the air, passing through the straw filter, joins
the water and an exchange of heat occurs. The filter has a water tubing
(hose) that spreads the water sent by the pump. Take out the straw and
clean the water exit holes with a needle to remove obstructions. Pass an
air blast in the holes and put the filter back in the water tank.