Publicidad
Idiomas disponibles
Idiomas disponibles
The declared vibration total value
has been measured in accordance
with a standard test method and
may be used for comparing one tool
with another.
The declared vibration total value
may also be used in a preliminary
assessment of exposure.
Warning!: the vibration emission
during actual use of the power tool
can differ from the declared total
value depending on the ways in
which the tool is used".
Warning!: avoid vibration risk
Suggestions:
1) wear glove during operation;
2) limit operating time and shorten
trigger time.
6. Assembly & Use
1. Switch button
2 .Drive shaft
3. Auxi handle
4. Gear box
5. Main handle
6. Protective cover (grinding)
7. Lock button
8. Spanner
9. External flange with thread
10. Internal flange
11. Button for rotating handle
Mounting the Auxi Handle
The side handle (3) can be screwed
in the hole on the left right or top of
the gear box (4). Select the position
which gives the most comfortable
and safe use.
During operation, keep one hand on
the rear handle (5) and the other on
the side handle (3).
Rotation of the Main handle
The rotation of the rear handle
(5) makes the operation more
comfortable.
Press the button (11) at the top of
the rear handle to rotate 90° degree
to the left side or right side.
Installing or moving protective cover
WARNING:
Ensure
grinder is switch off and unplugged
from the mains.
Depending
on
operation is cutting or grinding,
select the correct protective cover.
Failure to use the right cover for
operation could result in injury.
When using a grinding or cutting-off
wheel, the protective guard must be
fitted on the tool so that the closed
side of the cover always points
toward the operator.
Mounted the protective cover with
the protrusion on the cover band
aligned with the notch on the bearing
box. Then rotate the cover around
180° and close the fixed lever.
To remove the protective cover,
follow the installation procedure in
reverse.
the
angle
whether
your
10
Publicidad
