Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
SELF-CLEAN Operation
◆Functional description
the purpose of this function is to clean the
.
heat exchanger
◆Entry and exit：
1.Press SELF CLEAN button to enter this function, then
it will display "CL" on the panel of the indoor unit and also
on the remote controller.
2.The air conditioner first conducts self-cleaning for the indoor heat
exchanger，and then conducts self-cleaning for the outdoor heat
exchanger after a period of time, the whole cycle lasts for 20-30
minutes.
3.This function will exit automatically with the " Pi " sound
twice,then the unit return to original state.
4.Under operation process of SELF CLEAN, press the button
repeatedly is invalid and cannot exit, please press the
"power" button or swift to other mode to exit.
◆ Note:
1.This function is effective in the cooling and dehumidifying
mode and is invalid in the sleep/timer mode.
2.After entering the self-cleaning function, the indoor air
volume will decrease or no wind will blow out, and the fan
may stop, but the compressor won't stop;
3. During the operation, the indoor unit conducts self-cleaning,
and there may be cold air blowing out; the indoor unit conducts
self-cleaning, and there may be warm air blowing out;
4. During the self-cleaning, the heat exchanger may have
frost formed accompanied by poop sound; the connecting
pipe and valves of the outdoor unit may also have frost
formed.
5. To enhance the cleaning effects, the air deflectors may be
in different positions and the remote controller cannot be
used.
6. Depending on the different working environment of the
indoor and outdoor unit, cleaning effects of the heat
exchanger may vary.
7. The "CL" display time may last differently on the remote
controller and panel.
8.If the outside ambient temperature below zero, error
code "F25 "may be occurred during self-cleaning operation ,
which is normal protection, please turn off the power
and to restart after 10 seconds .
9.The best condition to run this mode: the temperature is
20 ℃ ~27 ℃ and the humidity is 35 ％ ~60 ％ in the door,
the temperature is 25℃ ~38 ℃（ cooling season) and
＜10℃(heating season) out the door.
10.It is hard to frost if the air is too dry(humidity ＜ 20%). and
if the humidity is too high(humidity ＞ 70%),the condensate
water may increase, which may move away some frost.
5
:
indoor and outdoor
HEALTH AIRFLOW Operation
TIMER
SMART
HUMIDITY
AIR
STATUS
and outlet grills of the air conditioner are opened, and
the unit goes on working under the condition before the
grille will close automatically.
Notice:
Cannot pull direct the outlet grille by hand. Otherwise, the
grille will run incorrectly. If the grille is not run correctly,
stop for a minute and then start, adjusting by remote
controller.
Remote controller can memorize each operation status.
when starting it next time, just press ON/OFF button and
unit will run in previous status.
Note:
2. In heating, it is better to select the
3. In cooling, it is better to select the
4. In cooling and dry, using the air conditioner for a
long time under the high air humidity, a phenomenon
falling drips of water occurs at the outlet grille.
5. Select the appropriate fan direction according to the
actual conditions.
The setting of
function
appears on the display. Avoid
the body.
again,
appears on the display.
direct to the body.
The cancel of
function
mode.
mode.
Publicidad
