Profi Care PC-VL 3062 M Manual De Instrucciones página 26

English
26
• This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental ca-
pabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance
in a safe way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children
without supervision.
Scope of delivery and parts description
1 Rotary switch for speed
2 Control knob for oscillation
3 Motor
4 Flattened area on the motor shaft
5 Rear protective grid
6 Locking screw for propeller
7 Hook
8 Fastening screw for protective grid
9 Front protective grid
10 Propeller
11 Fastening nut
12 Stand
13 Small knurled screw
14 Power cord
Without illustration:
4 screws for rear protective grid
Unpacking the Device
1. Remove the device from its packaging.
2. Remove all of the packaging material such as foils, filling
material, cable holders and cardboard packaging.
3. Check the scope of delivery.
4. Check the appliance for any transport damage to prevent
a hazard.
NOTE:
There may still be dust or production residues on the sur-
face of the device. We recommend that you quickly wipe
off the housing with a damp cloth.
Assembly instructions
The device must be completely assembled before initial
operation!
WarnIng: Risk of injury!
The edges of the propeller are sharp. Use caution during
assembly.
NOTE:
• You will need a Phillips screwdriver of medium size for
the assembly.
• All screws are preassembled on the individual parts.
• Also observe the "Overview of the Components" on
page 3.
1. Unscrew the 4 preassembled outer screws from the front
of the motor.
2. Hold the rear protective grid so that the 4 boreholes on
the protective grid are exactly above the 4 boreholes on
the motor.
NOTE:
Ensure that the carrying handle on the protective grid is
pointing upwards.
3. Mount the rear protective grid with the 4 screws.
4. Attach the propeller and fasten it with the locking screw.
CAUTION:
The screw must sit on the flattened side of the motor
shaft!
5. Attach the front protective grid by hanging the hook with
the nut into the rear protective grid.
NOTE:
Ensure that the holes on the grid edge for the fastening
screw in the front and rear protective grid are posi-
tioned above each other.