Tabla de contenido
Publicidad
Use and care recommendations
It is recommended to use a 10 AWG (5.26 mm
INDEPENDENT CHARGING CENTER.
Perform periodic MAINTENANCE to your machine. (Page 11)
2
ENGLISH
The tool has a THERMAL PROTECTOR that in case of overheating
turns the welder off and a LED light turns on. If this happens, let the
welder cool for 15 minutes and turn it back on.
Contents
3
3
To gain the best performance of
the tool, prolong the duty life,
4
make the Warranty valid if
necessary, and to avoid hazards
5
of fatal injuries please read and
understand this Manual before
6
7
Keep this manual for future references.
8
The illustrations in this manual are for reference
9
only. They might be different from the real tool.
11
11
12
13
14
) extension cord and connect it to an
2
CAUTION
using the tool.
Publicidad
Tabla de contenido
