Seca 959 Manual De Instrucciones Y Garantía página 69

Continuous display of
measured
result (HOLD)
3. Hold down the arrow key (hold/tare) until "NET"
appears in the display.
tare
4. Wait until the display stops flashing and is replaced
0. 0 0
by
5. Weigh the patient as described in section "Start
weighing".
6. Read off the measured result.
The additional weight has been automatically
deducted.
7. To disable the TARE function, press the arrow key
(hold/tare) until "NET" no longer appears in the
tare
display or switch off the scales.
NOTE:
The maximum weight that can be displayed is
reduced by the weight of the objects already
placed on the scales.
If you activate the HOLD function, the weighing value
will continue to be displayed after the load has been
removed. This allows you to attend to the patient
before noting down the weight.
1. Check that there is no load on the scales.
2. Switch the scale on.
3. Weigh the patient as described in section "Start
weighing".
4. Briefly press the arrow key (hold/tare).
tare
The display will flash until a stable weight is meas-
ured. The weighing value will then be displayed
continuously. The
tion) and the message "HOLD" will be displayed.
5. To disable the HOLD function, briefly press the ar-
row key (hold/tare).
tare
The
longer be displayed.
NOTE:
If the auto hold function is activated, the weight
value is displayed permanently automatically
until the scale switches itself off or is switched
off (see "Activate Autohold function (Ahold)" on
page 74).
.
symbol (non-calibratable func-
symbol and the message "HOLD" will no
English
Operation • 69