HOLZMANN MASCHINEN SB 3116RHN Manual De Instrucciones página 43

8. Lift the Head Assembly and insert the Column Guide (18) over the Column (B1).
Slide it down on the Column Tube as far as it will go. Align it so that it faces straight forward, in
line with the Base.
9. Insert one Locking Shoe (15) into place inside the bottom of the Column Guide (18), and the
other on the outside of the Column Guide. Tighten the Clamping Lever (30) into the Locking Shoe
at the base of the Column Guide.
10. Locate the Feed Knobs (34) and Feed Rods and screw into the Hub.
11. Install the Chuck (A12). Thoroughly clean the tapered hole in the Chuck and the Spindle
(A15) shaft of all dirt, grease, oil, and protective coatings (paint thinner may be necessary). Slide
the Chuck onto the Spindle shaft. Turn the Chuck sleeve clockwise and open the jaws completely.
Tap the nose of the Chuck lightly with a piece of wood to securely set the Chuck.
12. Verify that the Table is square (90 degrees) to the Head Assembly
and drill bit.
13. Adjust V-Belt tension or change speeds.
- Open the Belt Guard (A25) to expose the V-Belt.
- Loosen the Thumb Nut (28) to relieve the V-Belt tension.
- Push the Motor backward, tightening the Belt on the pulleys, and hold in place.
- Turn the Thumb Nut (28) clockwise to tighten the V-Belt in place.
- Refer to the chart inside the Guard lid to select speed and belt locations.
Overtightening the belts can cause the motor to bind and not start.
It can also damage motor bearings!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
W A R N U N G
ASSEMBLY
43
SB 3116RHN / SB 3116RMN