Publicidad
IMPORTANT WARNING! It is critical that all Yakima racks and accessories be properly and securely attached to
your vehicle. Improper attachment could result in an automobile accident, and could cause serious bodily injury
or death to you or to others. You are responsible for securing the racks and accessories to your car, checking
the attachments prior to use, and periodically inspecting the products for adjustment, wear, and damage.
Therefore, you must read and understand all of the instructions and cautions supplied with your Yakima
product prior to installation or use. If you do not understand all of the instructions and cautions, or if you have
no mechanical experience and are not thoroughly familiar with the installation procedures, you should have
the product installed by a professional installer such as a qualified rack specialty installer or auto body shop.
1
REMOVE THE COVERS.
3
INSTALL THE BASE.
For each Landing
Pad
install 2 screws
™,
each with a washer
and spacer. Align
the screws with the
plates you installed
in step 2. Do not fully
tighten yet.
NOTE: For use in Classic
Yakima Tracks use the
plastic washers. For use in
Yakima HD Tracks do not
use the plastic washers.
Instruction #1036088A - Page 2 of 5
2
INSTALL THE PLATES.
Slide 1 plate into
each HD Track.
2X
2X
4
POSITION YOUR LANDING PADS
5
SECURE THE LANDING PADS
4X
4X
Position the Landing
Pads on the tracks in the
approximate location
where Skyline
or Control
™
Towers
will be attached.
™
Use the hex wrench to fully
tighten the hardware to 4 Nm.
4 Nm
2X
2X
.
™
.
™
NOTE: Never drive
without the Landing
Pads fully tightened!
Doing so could result in
the landing pads falling
off of your vehicle.
4X
4X
Publicidad
