Publicidad
Idiomas disponibles
Idiomas disponibles
CE Marking
This device is compliant with the mandatory EU directives for CE marking.
Device parts and items included
1.
Handle with 3-position switch
2.
Battery
3.
Motor pre-filter
4.
Dust container insert with filter screen (detachable)
5.
Dust container
6.
Floor tool with brush roller
7.
2-in-1 tool
8.
Crevice tool
9.
Suction tube
10. Connection socket (rear of unit)
Not illustrated:
Power supply
Wall mounting bracket with fastening components
Assembling the appliance
Remove any remaining packaging from the device and assemble the component parts as shown in Figure I:
1.
If necessary, attach the dust container (also see the "Cleaning the dust container" section)
2.
Push the suction tube onto the device.
3.
Push the floor tool / 2-in-1 tool / crevice tool onto the suction tube.
4.
Push the device onto the wall mounting bracket.
Installing the wall mount
Charging the rechargeable battery
It is best to charge the rechargeable battery before each use, especially after the appliance has not been used for a while.
This increases the service life of the rechargeable battery and ensures the longest possible cleaning cycles.
1.
Plug the connector for the mains adapter included in the delivery into the connection socket of the appliance.
2.
Connect the mains adapter included in the delivery to a socket.
- The LEDs on the handle start to flash. The more the LEDs flash, the more advanced the charging process is.
- As soon as the rechargeable battery is fully charged, all of the LEDs light up for 5 minutes and then go out. The
charging process takes around 5 hours when the rechargeable battery is empty.
3.
Disconnect the mains adapter from the socket.
4.
Disconnect the mains adapter's connector from the connection socket on the appliance.
14
Device parts/Assembly
1.
Hold the wall mount to the wall, aligned in a vertical position.
2.
Mark the holes with a pencil.
3.
Drill the holes (approximately 8 mm Ø).
4.
Insert the dowels included in the delivery into the holes.
5.
Fasten the wall mount using the screws included in the delivery.
6.
If necessary, slide the cable through the cable routing (see arrows).
Charging the rechargeable battery
Publicidad
