Stiga SHP 60 Manual De Instrucciones página 78

12 IDENTIFICATION OF FAULTS / TECHNICAL SPECIFICATIONS / ACCESSORIES
EN
8. IDENTIFICATION OF FAULTS
PROBLEM
1) The engine
will not start
or will not
keep running
2) The engine starts
but is lacking
in power
3) The engine runs
irregularly and lacks
in power when
revved
4) The engine gives
off an excessive
amount of smoke
9. TECHNICAL SPECIFICATIONS
Capacity
Power
Spark plug
Petrol : Oil ratio
Tank capacity
Trimming lenght
Weight
Measured sound pressure level at ear's operator
- Measurement uncertainty
Measured sound power level
- Measurement uncertainty
Guaranteed acoustic power level
Vibrations transmitted to the hand on the front handgrip
- Measurement uncertainty
Vibrations transmitted to the hand on the rear handgrip
- Measurement uncertainty
10. ACCESSORIES
Only cutting tools with the following codes must be
used on this machine:
23305004/0
LIKELY CAUSE
– Incorrect starting procedure
– Dirty spark plug or incorrect distance
between the electrodes
– Air filter clogged
– Carburation problems
– Air filter clogged
– Carburation problems
– Dirty spark plug or incorrect
distance between the electrodes
– Carburation problems
– Incorrect composition
of the fuel mix
– Carburation problems
SOLUTION
– Follow the instructions
(see chap. 5)
– Check the spark plug
(see chap. 7)
– Clean and/or replace the filter
(see chap. 7)
– Contact your Retailer
– Clean and/or replace the filter
(see chap. 7)
– Contact your Retailer
– Check the spark plug
(see chap. 7)
– Contact your Retailer
– Prepare the fuel mix according to
the instructions (see chap. 4)
– Contact your Retailer
Given the product evolution, the above mentio-
ned tools may be replaced in time by others, with
similar interchangeable and operating safety cha-
racteristics.
cm 24,5
3
kW 0,85
BOSCH L8RTF
40 : 1
liters 0,41
mm 550
kg 5,5
dB(A) 88,9
dB(A) 2,5
dB(A) 106
dB(A) 2,5
dB(A) 109
m/s 2,182
2
m/s 1,5
2
m/s 2,034
2
m/s 1,5
2