Before initial use
Charging the battery pack
(see fig. A)
CAUTION!
►
Always unplug the appliance before you
remove the battery pack
the battery pack to the high-speed charger
NOTE
►
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C.
♦
Connect the battery pack
charger.
♦
Insert the power plug into the mains power
socket. The red control LED
♦
The green control LED
charging process is complete and the battery
pack
is ready for use.
CAUTION!
♦
If the red control LED
that the battery pack
cannot be charged.
♦
If the red and green control LEDs
flash simultaneously, this means that the
battery pack
is defective.
♦
Fit the battery pack
PAHE 20-Li D4
from or connect
to the high-speed
will light up.
indicates that the
flashes, this means
has overheated and
back onto the appliance.
Attaching/disconnecting the battery
pack to/from the device
Attaching the battery pack
♦
Allow the battery pack
handle
of the appliance.
Removing the battery pack
♦
Press the release button
.
battery pack
Checking the battery charge level
♦
Press the battery charge level button
check the status of the battery. The status/
remaining charge will be shown on the battery
display LED
RED/ORANGE/GREEN = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery
Fixing/attaching the shoulder strap
♦
Hook the shoulder strap
lug
.
♦
Adjust the length of the shoulder strap
your size so that carrying lug
when hooked in place.
♦
In addition, you can adjust the height of the
carrying lug
loosening the screw.
to click onto the rear
and remove the
.
as follows:
into the carrying
is at hip height
on the appliance shaft
GB │ IE
│
to
to
by
11
■