NOTE
►
The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with a
standardised test procedure and can be used
for comparison of the power tool with
another tool.
►
The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate.
WARNING!
►
Depending on the manner in which the
power tool is being used, and in particular
the kind of workpiece that is being worked,
the vibration and noise emission values can
deviate from the values given in these instruc-
tions during actual use of the power tool.
►
It is necessary to establish safety measures to
protect the operator based on an estimation
of the vibration load during actual use (all
states of operation must be included, e.g.
times when the power tool is switched off and
times where the power tool is switched on but
running without load).
Explanation of symbols on the appliance
Read the operating instructions
and safety advice before initial
operation!
Wear protective gloves!
Wear safety shoes!
Wear ear protection!
Wear a hard hat!
Wear safety goggles!
■
4
│
GB │ IE
Keep bystanders away from the
appliance!
Do not use chain saw one-handed!
Always use chain saw two-handed!
Beware of chain saw kickback and
avoid contact with bar tip!
Protect the appliance against rain or
moisture!
Keep at least 10 m away from over-
head lines and at least 15 m to other
people.
Caution! Falling objects.
Especially when cutting above head
height.
Beware of thrown objects!
Caution! Risk of injury due to
running blades.
Sound power level LWA data in dB.
Turn the device off and remove the
battery pack before performing any
maintenance work!!
A full tank will last for approx.
15 minutes of continuous operation.
Running direction of the chain!
Oil filler cap
Minimum/maximum level indicator
MIN/MAX
of the oil tank.
Tighten!
Release!
The arrow direction marks the
selected position.
Press in the direction of the arrow.
PAHE 20-Li D4