Descargar Imprimir esta página

EGAmaster 57078 Manual De Instrucciones página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

The tool should only be used as a handheld hand operated tool. It is always recommended that
the tool is used when standing on the solid floor. It can be used in other positions but before any
such use, the operator must be in a secure position having a firm grip and
footing and be fully aware that when loosening fasteners the tool can move quite quickly away
from the fastener being undone. An allowance must always be made for this backward movement
so as to avoid the possibility of any hand/arm/ body entrapment.
Select a suitable mounting point that has a free running speed higher than the maximum running
speed marked on the tool. Make sure that the diameter of the shank exactly matches the diameter
of the collet mounted in the grinder. There are four standard sizes of collet available for use with
this grinder, i.e.
1) - 1/4" dia (0.250ins)(6.35mm)
2) - 6mm (0.236ins)
3) - 1/8" (0.125ins) (3.175mm)
4) - 3mm (0.118ins)
Never try to force a 1/4" diameter shank into a 6mm collet or a 1/8" diameter collet to secure a
3mm diameter shank. Always match correctly the shank size to the collet size. If uncertain, have
parts measured by a trained person. Push the shank as far as possible into the collet and tighten the
collet nut using the spanners provided on the collet nut and output spindle.
Use a clean lubricated air supply that will give a measured air pressure at the tool of 90 PSI with
the trigger fully depressed.
Use recommended hose size and length. It is recommended that the tool is connected to the air
supply as shown in figure A.
Do not connect the tool to the air line system without incorporating an easy to reach and
operated shut off valve.
It is strongly recommended that an air filter, regulator, lubricator (FRL) is used as shown in
figure A as this will supply clean, lubricated air at the correct pressure to the tool. Details of such
equipment can be obtained from your supplier. If such equipment is not used then the tool should
be lubricated by shutting off the air supply to the tool, depressurising the line by pressing the trigger
on the tool.
Disconnect the air line and pour into the intake bushing a teaspoon (5 ml) of a suitable
pneumatic motor lubricating oil preferably incorporating a rust inhibitor. Reconnect tool to air
supply and run tool slowly for a few seconds to allow air to circulate the oil.
If tool is used frequently lubricate on daily basis and if tool starts to slow or lose power.
10
WORK STATIONS
INITIAL OPERATION
AIR SUPPLY

Publicidad

loading

Este manual también es adecuado para:

570795708157080